How To Drywall Around A Corner

When it comes to drywalling, one of the areas that can be tricky to get right is around corners. If you don't do it properly, you can end up with gaps or uneven surfaces. In this article, we'll walk you through the steps on how to drywall around a corner properly. We'll cover everything from measuring and cutting the drywall to installing it and finishing it off. So, whether you're a beginner or a pro, read on for some helpful tips and tricks.

Measuring and Cutting the Drywall

The first step is to measure and cut the drywall to size. To do this, you'll need to measure the length of the corner and then add about 2 inches to that measurement. This will give you the length of the drywall that you need to cut. Once you have the length, you'll need to measure and mark the width of the drywall. The width should be the same as the width of the wall that you're drywalling.

Once you have the measurements, you can cut the drywall to size. To do this, you can use a utility knife or a drywall saw. If you're using a utility knife, score the drywall along the cut line and then snap it in half. If you're using a drywall saw, simply cut along the cut line.

Installing the Drywall

Once you have the drywall cut to size, you can install it on the wall. To do this, you'll need to apply a bead of drywall adhesive to the back of the drywall. Once you have the adhesive applied, you can press the drywall into place on the wall. Make sure that the drywall is flush with the wall and that there are no gaps.

Once the drywall is installed, you can screw it into place. To do this, use drywall screws and a power drill. Drive the screws into the drywall about every 6 inches. Make sure that the screws are countersunk into the drywall so that they don't stick out.

Finishing the Drywall

Once the drywall is installed, you can finish it off by taping and mudding it. To do this, apply a layer of joint compound to the seams between the drywall sheets. Then, embed fiberglass mesh tape into the joint compound. Once the tape is embedded, apply another layer of joint compound over the tape. Once the joint compound is dry, you can sand it smooth. Then, you can paint the drywall to match the rest of the wall.

By following these steps, you can drywall around a corner like a pro. Just take your time and be careful, and you'll be able to get a great-looking finish.