Kingston Brass Wall Mount Faucet Installation

Kingston Brass Wall Mount Faucet Installation: A Step-by-Step Guide

Transforming your bathroom or kitchen with a stylish and functional wall mount faucet can be an exciting project. Kingston Brass, renowned for its exceptional craftsmanship, offers a wide selection of wall mount faucets to complement any décor. Installing these faucets may seem daunting, but with proper planning and a few simple steps, you can achieve a flawless installation.

Essential Tools and Materials:

Adjustable wrench
Phillips and flathead screwdrivers
Pliers
Teflon tape (plumber's tape)
Caulk gun with silicone caulk
Basin wrench (optional)

Step-by-Step Installation Instructions:

1. Prepare the Installation Area:

Shut off the water supply valves under the sink or behind the faucet. Open the faucet handles to release residual water in the lines. Remove the old faucet or determine the location for the new installation.

2. Mark the Wall Mount Holes:

Use the included template or masking tape to mark the wall mount holes. Ensure they are level and align correctly with the faucet base. Drill pilot holes slightly smaller than the mounting screws.

3. Install the Escutcheon:

Apply a thin bead of silicone caulk around the base of the escutcheon plate. Press the escutcheon firmly onto the wall, aligning the holes with the pilot holes. Secure it with the provided screws.

4. Attach the Faucet Base:

Wrap Teflon tape around the threads of the faucet base where it will connect to the water supply lines. Insert the faucet base into the escutcheon holes and secure it with the mounting nuts.

5. Connect the Water Supply Lines:

Attach the flexible supply lines to the water supply valves using adjustable wrenches. Ensure that the hot and cold lines are connected correctly. Apply Teflon tape to the threaded connections for a watertight seal.

6. Install the Faucet Handle:

Insert the faucet handle into the handle stem and secure it with the provided screw or set screw. Tighten it until snug but not overly tight.

7. Adjust the Flow Rate:

Turn on the water supply and check for leaks. If there are leaks, re-tighten the connections or apply additional Teflon tape. Adjust the flow rate by loosening or tightening the flow control screw located behind the handle.

8. Caulk and Clean:

Apply a bead of silicone caulk around the base of the faucet where it meets the escutcheon and the wall. Smooth the caulk with a damp sponge or your finger. Wipe the faucet and escutcheon with a soft cloth to remove any smudges or residue.

Tips for a Successful Installation:

Use a level to ensure proper alignment of the faucet base and escutcheon.
Tighten all connections securely but avoid over-tightening.
Apply Teflon tape to all threaded connections to prevent leaks.
Test the faucet thoroughly for leaks before caulking.
Use a basin wrench to reach the mounting nuts if they are difficult to access.

By following these steps meticulously, you can achieve a professional-looking and leak-free installation of your Kingston Brass wall mount faucet. If you encounter any difficulties, refer to the manufacturer's instructions for additional guidance.